Your default login is menu, not the CLI.
Telnet or ssh into the switch, you'll be presented with a menu, select option 8 (Run Setup) then move around to the Logon Default and change the option to say CLI. Save your setup and you're good to go.
--
Tighe Schlottog
Peabody Energy
W: 314.342.7868
C: 618.580.8166
-----Original Message-----
From: rancid-discuss-***@shrubbery.net [mailto:rancid-discuss-***@shrubbery.net] On Behalf Of Mark Boolootian
Sent: Thursday, August 20, 2009 1:20 PM
To: rancid-***@shrubbery.net
Subject: [rancid] trouble with HP 2650
I'm running rancid-devel-2.3.2a10 (port build on FreeBSD 7.0) and
am not having luck with an HP 2650. When I hlogin to the device,
I end up watching the clock updating - but no prompt. I have to CTRL-C
to exit. Any thoughts on where I'm going wrong?
_______________________________________________
Rancid-discuss mailing list
Rancid-***@shrubbery.net
http://www.shrubbery.net/mailman/listinfo.cgi/rancid-discuss
-----------------------------------------
E-mail Disclaimer:
The information contained in this e-mail, and in any accompanying
documents, may constitute confidential and/or legally privileged
information. The information is intended only for use by the
designated recipient. If you are not the intended recipient (or
responsible for the delivery of the message to the intended
recipient), you are hereby notified that any dissemination,
distribution, copying, or other use of, or taking of any action
in reliance on this e-mail is strictly prohibited. If you have
received this email communication in error, please notify the
sender immediately and delete the message from your system.