Slacker T
2010-08-26 22:35:52 UTC
Hello all,
I'm new with rancid, so please forgive any naivety!
I'm trying to setup rancid to access a F5 3600 LTM running 10.2. The
account that rancid uses is a limited account, it's Role is "guest" and it's
terminal access is set to "bigpipe shell". It's basically a read-only
account that can only list the config. The prompt that this user gets is
"bp>". Currently the only command I need to run is "b list".
Does rancid version 2.3.4 support this out of the box? Or do I need to edit
something outside of .cloginrc and router.db?
Would I be better off abandoning this approach and just allow the user full
shell access, i.e. root with a "***@hostname ~ #" prompt?
FWIW, I do have rancid working fine with other Cisco and Juniper devices.
I'm new with rancid, so please forgive any naivety!
I'm trying to setup rancid to access a F5 3600 LTM running 10.2. The
account that rancid uses is a limited account, it's Role is "guest" and it's
terminal access is set to "bigpipe shell". It's basically a read-only
account that can only list the config. The prompt that this user gets is
"bp>". Currently the only command I need to run is "b list".
Does rancid version 2.3.4 support this out of the box? Or do I need to edit
something outside of .cloginrc and router.db?
Would I be better off abandoning this approach and just allow the user full
shell access, i.e. root with a "***@hostname ~ #" prompt?
FWIW, I do have rancid working fine with other Cisco and Juniper devices.