Me too have the same problem... I am on 2.3.2a9... Can someone help!!!
Post by Ryan DeBerryYes, I am using cat5 as the device type. I can run clogin and it works
fine. rancid-run produces the following log.
missed cmd(s): write term all,show port ifindex,show module,dir
sup-microcode:,dir sup-bootflash:,dir bootflash:,dir slot0:,show
version,show flash,show running-config,write term,show boot,dir slot1:,show
inventory raw
: End of run not found
Below is a link to old thread.
http://osdir.com/ml/network.rancid/2008-06/msg00018.html
Post by Michael StefaniucPost by Ryan DeBerryI have seen many posts in the archives with the same issue but I have
not
Which rancid version are you using? I have submitted patches to fix the
problem and those were accepted (in a modified) form upstream. I use
rancid-2.3.2a8 and the only CatOS specific patch I have is to kill the
bogus "set portcost" config lines.
Post by Ryan DeBerryclogin works just fine but rancid-run spits out error timeout reached
Btw. what device type are you using for the CatOS devices: "cisco" or
"cat5"? "cat5" is the correct type.
bye
michael
--
Michael Stefaniuc Tel.: +49-711-96437-199
Consulting Communications Engineer Fax.: +49-711-96437-111
--------------------------------------------------------------------
Reg. Adresse: Red Hat GmbH, Otto-Hahn-Strasse 20, 85609 Dornach bei Muenchen
Handelsregister: Amtsgericht Muenchen HRB 153243
Geschäftsführer: Brendan Lane, Charlie Peters, Michael Cunningham,
Werner Knoblich
_______________________________________________
Rancid-discuss mailing list
http://www.shrubbery.net/mailman/listinfo.cgi/rancid-discuss