[rancid] Cisco clock warnings

[Willie Bollinger]

We recently installed some adsl cards in some cisco routers that we use
for out of band management. Ever since we did this we get the following
errors from rancid every time it runs.

!
!Interface: FastEthernet0/0, AMD Am79c971
! DTE Unknown (13) TX and RX clocks detected.
- ! DTE Unknown (13) TX clock detected.
+ ! DTE Unknown (13) TX and RX clocks detected.
!
!Slot 0: fru C2620
!Slot 0: type C2620 1FE Mainboard, 4 ports
!Slot 0: hvers 6.0 rev B0

Is there a way to make rancid ignore these errors or has anybody come
across a similar problem?

[Kevin Bonner]

Hi Willie,

If you're getting the same email on every rancid run, I would suspect that
your revision control system is having problems checking in that change. Do
the logs for that host / run indicate that rancid had trouble checking in the
change to SVN (or CVS)?

-Kevin

Post by Willie Bollinger
We recently installed some adsl cards in some cisco routers that we use
for out of band management. Ever since we did this we get the following
errors from rancid every time it runs.
!
!Interface: FastEthernet0/0, AMD Am79c971
! DTE Unknown (13) TX and RX clocks detected.
- ! DTE Unknown (13) TX clock detected.
+ ! DTE Unknown (13) TX and RX clocks detected.
!
!Slot 0: fru C2620
!Slot 0: type C2620 1FE Mainboard, 4 ports
!Slot 0: hvers 6.0 rev B0
Is there a way to make rancid ignore these errors or has anybody come
across a similar problem?